https://www.etsy.com/listing/931303989/high-end-leather-craft-skiving-machine

On a side note. I did swap out the 50mm foot for the 30mm and had much better results. I examined the 50mm and found quite a few burrs. I buffed and polished those out and the results are much better.

It does seem like the edges have a more gradual taper. He also says he has slightly changed the radius of the presser foot to better compliment the bell knife itself and then brings them to a high polish. I’m happy to share the makers info if that’s allowed here?

The only issue I’ve run into seems to be pretty common in that the presser foot will leave marks on some leather. I have found after market presser feet that a gentleman in Vietnam makes and the reviews are amazing however they are not cheap. I’m torn between ordering new feet from him and just getting standard spare one and grinding and polishing them myself. I’ll also note that the marks may very well also be user error.

I appreciate the advice. I did order a rubber feed roller as mine did come equipped with a stone one. I didn’t think about a spare bell knife but I’ll definitely look into that as well. I haven’t gotten to play around with it too much as mine did not come assembled and had zero assembly instructions, but after many hours I finally have everything assembled and running. So far I’m quite happy and it seems that it will be a huge time saver.

There are quite a few service centers within a half hour drive. I did a bit of research and found exactly what you’re saying. They all seem to be the same to me. In the end I decided on the Consew DCS-S4. The machine was shipped over night free of charge so it’s already put together and in place. I’m now watching the techniques of the bell skiver video for the third time before I attempt final setup. I will say this video is a life saver and this machine would have been extremely difficult to figure out without it.

Thank you. This helps a lot. I have used Fil au chinois with little success but perhaps I should try Meisi.

I agree. Any suggestions? I was looking at Maine thread company but I don't know much about them. I also never know what would be a good all around size to go with.

Thank you Fadi. Much appreciated! Yes, Tiger thread 0.6