Hi guys, this card wallet is just an experiment following Phil video on making slots using ripstop nylon using glue template. How thin is the limit for making the leather slots, the front most pocket as well as the back. In the photo, the back is 0.5mm, the slots is 0.5mm (folded 1mm), the front most pocket is 0.7mm. Should i go thinner than this and using reinforcement tape?
top of page
Like
2
5
Like
1
1
bottom of page
Nah, I think you went as thing as possible.
You can maybe remove 01. or 0.2 mm from the front pocket, but that will really not change anything.
Also, remember if you remove 0.2mm from a leather and then add 0.2mm of reinforcement tape, it was all for nothing :)